Rods are available for both stands and attaching ramps to skid seats
When ordering please specifiy the width of your Skid Seats or if the rod is for the Stand
All steel rods for ramp attachment are 3/4″ in diameter
All rods accept the Standard Hitch Pin
That set covers all the bolts and nuts you need for the installation of your ramp set.
Make sure you let us know about Make of your trailer.
Holds ramps upright for use as levelers (1 pair required per ramp, 1 left (shown) & 1 right
Use chain binder with up to 3/8 chain to securely fasten stakes to trailers stake pockets
Eight heights available to accomodate different trailer drops; 16″, 18″, 19″, 20″, 21″, 22″, 24″, and 26″
Getting the correct stakes is important. When using spacers, stake height = ramp width + spacer height used.
Some trailers have a narrow pocket. Measure stake pocket to be sure to get correctly sized stake inserts.
Stake inserts are designed to be reversed to allow for up to a 1″ difference in trailer rub rail widths
There are two sizes
Ramp Hanger Keeper Long for double ramp hangers holding ramps with 6″ tubes
Ramp Hanger Keeper Short for single ramp hangers and stand hangers
These keepers will also accommodate padlocks in place of the Lynch Pin Keeper
Heavy Duty Ramp Set comes with;
– 4 of 8 Feet Ramps
– 2 of Hanging Support Stands
– 4 of Double Ramp Hangers
– 2 of Stand Hangers
– 4 of Skid Seats
– 4 of Stakes (Can use ramps as levelers)
– 6 of Lumber Clips (Can use ramps as levelers)
– Complete Bolt Kit Special for Your Trailer