PART# Q6895 5 Capacities: 32,000; 23,500; and 20,000, 15,000 and 10,000 lbs.maximum per axle. 32,000 lb. max per axle ramp in 18″ and 20″ widths 23,500 lb. max per axle ramps in 18″, 19″, and 20″ widths. 20,000 and 10,000 lb. max per axle ramp in 16″ width 15,000 lb. max per axle ramp in 18″ & 20″ width All ramps are 8 feet in length All ramps have pin ends for secure connection to the trailer (requires Skid Seat) and stands 20,000 & 32,000 lb. max per axle rated ramps are 6 inches thick, others are just 5″ thick Converts to a Leveler with the use of optional stakes Three lumber clips per ramp required when used as load levelers. May be hung from beneath your trailer for easy transport using optional hanging system

PART# RHKeeperL There are two sizes Ramp Hanger Keeper Long for double ramp hangers holding ramps with 6″ tubes Ramp Hanger Keeper Short for single ramp hangers and stand hangers These keepers will also accommodate padlocks in place of the Lynch Pin Keeper

PART# Q2520LH Holds ramps upright for use as levelers (1 pair required per ramp, 1 left (shown) & 1 right Use chain binder with up to 3/8 chain to securely fasten stakes to trailers stake pockets Eight heights available to accomodate different trailer drops; 16″, 18″, 19″, 20″, 21″, 22″, 24″, and 26″ Getting the correct stakes is important. When using spacers, stake height = ramp width + spacer height used. Some trailers have a narrow pocket. Measure stake pocket to be sure to get correctly sized stake inserts. Stake inserts are designed to be reversed to allow for up to a 1″ difference in trailer rub rail widths

PART# HitchPin Hitch Pin Clip for Rods and Pins