Carries ramps beneath the trailer
Available in both Single and Double hangers
Order as a pair, left and right for both the single and double ramp hanger
There must be, at a minimum, 99″ of clear space to mount hangers
Ramp Hangers are complete with Keepers and Pins
Shows pair on the picture. It comes only one!
Available in 36″
Welding to trailer is preferred because of its strength, but bolting to trailer may be used.
May be trimmed to fit around stake pockets on upper or rear deck
May be mounted to either or both upper and lower decks
Be sure to order the type appropriate for the deck being equipped
Aluminum Skid Seats come equipped with Rods and Standard Hitch Pins
Heavy Duty Ramp Set comes with;
- 4 of 8 Feet Ramps
- 2 of Hanging Support Stands
- 4 of Double Ramp Hangers
- 2 of Stand Hangers
- 4 of Skid Seats
- 4 of Stakes (Can use ramps as levelers)
- 6 of Lumber Clips (Can use ramps as levelers)
- Complete Bolt Kit Special for Your Trailer
May also be known as Dunnage holders
Three required for each ramp used as a load leveler
Comes in both 6″ wide, for 20K max per axle ramps, 5″ wide for all other ramps
Required for use atop spacers to protect the aluminum ramp and spread the load
5 Capacities: 32,000; 23,500; and 20,000, 15,000 and 10,000 lbs.maximum per axle.
32,000 lb. max per axle ramp in 18″ and 20″ widths
23,500 lb. max per axle ramps in 18″, 19″, and 20″ widths.
20,000 and 10,000 lb. max per axle ramp in 16″ width
15,000 lb. max per axle ramp in 18″ & 20″ width
All ramps are 8 feet in length
All ramps have pin ends for secure connection to the trailer (requires Skid Seat) and stands
20,000 & 32,000 lb. max per axle rated ramps are 6 inches thick, others are just 5″ thick
Converts to a Leveler with the use of optional stakes
Three lumber clips per ramp required when used as load levelers.
May be hung from beneath your trailer for easy transport using optional hanging system